Samsung Electronics
4-5
Steps
Remote control display
6 Set the SEG21 and SEG22 values:
a Set the SEG21 value by pressing the
(Low Fan) button repeatedly until the
value you want to set appears on the remote control display.
SEG21
b Set the SEG22 value by pressing the
(High Fan) button repeatedly until the
value you want to set appears on the remote control display.
When you press the
(Low Fan) or
(High Fan) button, values appear in the
following order:
SEG22
7 Press the
(Mode) button. Heat and Off appear on the remote control display.
8 Set the SEG23 and SEG24 values:
a Set the SEG23 value by pressing the
(Low Fan) button repeatedly until the
value you want to set appears on the remote control display.
SEG23
b Set the SEG24 value by pressing the
(High Fan) button repeatedly until the
value you want to set appears on the remote control display.
When you press the
(Low Fan) or
(High Fan) button, values appear in the
following order:
SEG24
3 Check whether the option values that you have set are correct by pressing the (Mode) button repeatedly
[SEG21, SEG22]
[SEG23, SEG24]
SEG24
SEG24
[SEG2, SEG3]
[SEG4, SEG5]
[SEG6, SEG8]
[SEG9, SEG10]
SEG10
SEG10
[SEG11, SEG12]
[SEG14, SEG15]
[SEG16, SEG17]
SEG17
SEG17
[SEG18, SEG20]
SEG20
SEG20
4 Save the option values into the indoor unit:
Point the remote control to the remote control sensor on the indoor unit and then press the
(Power) button on the
remote control twice. Make sure that this command is received by the indoor unit. When it is successfully received, you
can hear a short sound from the indoor unit. If the command is not received, press the (Power) button again.
