9
INSTALLATION INSTRUCTIONS
Remove Transport System
WARNING
Excessive Weight Hazard
Use two or more people to move and install washer .
Failure to do so can result in back or other injury .
Important note to installer:
Please read the following instructions carefully before
installing your washer.
These instructions should be retained for future reference.
We recommend you hire a professional to install this washer.
Selecting a Location
Before you install the washer, make sure the location:
• Has a hard, level surface without carpeting or flooring that may
obstruct ventilation.
• Is away from direct sunlight.
• Has adequate ventilation.
• Is not exposed to freezing temperatures (temperatures under
32 °F or 0 °C).
• Has enough space so that the washer doesn’t rest on its
power cord.
Connecting the water and the drain
Connecting the water supply hose
Before you Connect the inlet hoses to water faucets, check
to ensure a washer is inside coupling. Before installing the
water supply hoses, make sure there are rubber gaskets
inside the fittings at both ends of each new water hose.
Installing the water supply hoses without rubber gaskets
can cause water leakage.
When you initially install the washer, be sure to use new
hoses.
Failing to do so may result in a water leakage or overflow
and may damage your property.
Do not connect multiple water supply hoses together to
increase the length of the supply hose. Hoses connected
this way can leak and the leakage can cause electrical
shock and or damages to the floor due to water leaks. If a
hose is too short, replace the hose with a longer,high
pressure hose.
Connect the inlet hoses to the water faucets
Make sure the washer tub is empty.
1 .
Check the inlet hose to ensure a washer is inside each fill
hose.
Thread the inlet hoses to the HOT and COLD faucet
connections.
On the other end of the hose, check for one rubber washer
per hose and install each fill hose to the water valve. Make
sure the hose with the Hot printed line is attached to the HOT
faucet. Tighten by hand until snug, then two-thirds of a turn
with pliers.
NOTE:
For correct water use, connect both HOT and COLD
water valves. If either or both are not connected, an “nF” (no fill)
error can occur.
2 .
Turn on the “HOT” and “COLD “water supply and check all
connections at the water valve and the faucet for leaks.
NOTE:
Do not overtighten or use tape or sealants on the valve.
Damage to the valves can result.
CAUTION
CAUTION
CAUTION
Rubber Washer
Coupling
Cold
Hot
Rubber washer
ENGLISH
Hot printed
Cold printed
F900A WASHER_KENMORE_USER MANUAL_592-29336_DC68-03133N-01_EN.indd 9
2015/12/15 16:51:39
