Samson Type 5824, Mounting And Operating Instructions

Page: 21 / 64

EB 5824-1 EN 4-1
Shipment and on-site transport
4 Shipment and on-site trans-
port
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Compare the shipment received with the
delivery note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).
4.2 Removing the packaging
from the actuator
Do not remove the packaging until immedi-
ately before mounting and start-up.
1. Remove the packaging from the electric
actuator.
2. Check scope of delivery (see Fig. 4-1).
3. Dispose of the packaging in accordance
with the valid regulations.
1x Type 5824 or Type 5825 Electric Actuator
1x Document IP 5824-1
(Important Product Information)
Fig. 4-1: Scope of delivery
Note
4.3 Transporting the actuator
− Protect the electric actuator against exter-
nal influences (e.g. impact).
− Protect the electric actuator against mois-
ture and dirt.
− Observe the permissible transportation
temperature of –20 to +70 °C.
4.4 Lifting the actuator
Due to the low service weight, lifting equip-
ment is not required to lift the electric actua-
tor.
4.5 Storing the actuator
Risk of electric actuator damage due to im-
proper storage.
Î
Observe the storage instructions.
Î
Avoid long storage times.
Î
Contact SAMSON in case of different
storage conditions or longer storage
times.
We recommend regularly checking the elec-
tric actuator and the prevailing storage con-
ditions during long storage periods.
NOTICE !
Note