Samson TROVIS 6495-2, Mounting And Operating Instructions

Page: 33 / 186

EB 6495-2 EN 5-1
Installation
5 Installation
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
5.1 Installation conditions
Work position
The work position for the industrial controller
is the front view onto the operating controls
on the controller seen from the position of
operating personnel.
Operators must ensure that, after installation
of the industrial controller, the operating per-
sonnel can perform all necessary work safely
and easily access the controller from the
work position.
5.2 Preparation for installation
Before installation, make sure the following
conditions are met:
− The industrial controller is not damaged.
Proceed as follows:
Î
Lay out the necessary material and tools
to have them ready during installation
work.
5.3 Mounting the industrial
controller
The TROVIS 6495-2 Industrial Controller is
designed for panel mounting (see Fig. 5-2
and the 'Design and principle of operation'
section).
When installing several TROVIS 6495-2
Industrial Controllers, keep the minimum
distance between each controller (see
Fig. 5-2).
1. Make a panel cut-out with the dimen-
sions 92
+0.8
x 92
+0.8
mm.
2. Push the industrial controller into the
panel cut-out from the front.
3. Insert the mounting clamps into the top
and bottom recesses.
4. Turn threaded rods towards the panel us-
ing a screwdriver, clamping the housing
against the panel.
The IP rating will be lower if the controller
is not fastened properly.
Î
Tighten the threaded rods far enough to
ensure the specified IP rating is achieved.
Note
NOTICE !