Samson TROVIS 6495-2, Mounting And Operating Instructions

Page: 31 / 186

EB 6495-2 EN 4-1
Shipment and on-site transport
4 Shipment and on-site trans-
port
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Compare the shipment received with the
delivery note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent (re-
fer to delivery note).
4.2 Removing the packaging
from the industrial con-
troller
Do not remove the packaging until immedi-
ately before mounting and start-up.
1. Remove the packaging from the industri -
al controller.
2. Check scope of delivery (see Fig. 4-1).
3.
Dispose and recycle the packaging in ac-
cordance with the local regulations.
1x TROVIS 6495-2 Industrial Controller
1x Accessories
1x Seal
1x
14-pole screw terminal
1x 15-pole screw terminal
1x 6-pole screw terminal
1x 2-pole screw terminal
1x 8-pole screw terminal
2x Mounting clamp
2x Adhesive label kit
1x Document IP 6495-2
(Important Product Information)
Fig. 4-1: Scope of delivery
4.3 Transporting the industrial
controller
Transport instructions
− Protect the industrial controller against
external influences (e.g. impact).
− Protect the industrial controller against
moisture and dirt.
− Observe transport temperature depend-
ing on the permissible ambient tempera-
ture from –20 to +70 °C (see the 'Design
and principle of operation' section).
4.4 Lifting the industrial
controller
Due to the low service weight, lifting equip-
ment is not required to lift the industrial con-
troller.
Note