Torque Setting
The torque setting will regulate the driving power when using a screwdriver bit. This will help prevent
damage to the work piece and/or screw.
Always start with the lowest torque setting (1) and increase if necessary.
For drilling set the torque selector to the position indicated by the drill bit symbol.
Overload Protection:
When overloaded, the motor will stop. Relieve the load on the machine immediately and allow to run
for approx. 30 seconds at the highest no-load speed to cool down.
When used as intended, the power tool cannot be overloaded. When the load is too high or the
allowable battery temperature of 75°C is exceeded, the electronic control switches off the power tool
until the temperature drops to the optimum range.
MAINTENANCE AND CLEANING
Attention! Always remove the battery before carrying out any work on the machine.
To clean the tool, use a dry or moist, but not wet, towel. Many cleaning agents contain chemical
substances which may cause damage to the plastic parts of the tool. Do not use any strong or
inflammable cleaners such as petrol, paint thinner, turpentine or similar cleaning agents.
Always keep air ventilation holes free of dust deposits to prevent overheating. Wear a dust mask and
use a soft brush to clean the ventilation holes.
Servicing this tool must be done by a qualified person only. Service or maintenance
performed by unqualified personnel could result in a risk of injury.
If the tool does not work properly, return the tool to a service facility for repair.
If the supply cord is damaged it must be replaced only with the correct part by an authorised
service agent to avoid a safety hazard.
DISPOSAL:
Do not dispose of electrical appliances with your domestic waste!
Dispose of it
in your local recycling containers, or at your local recycling station.
TECHNICAL DATA
18V CORDLESS DRILL
SROM1170
Voltage Rating (charger)
230-240V, 50Hz input
24V 400mA DC output
Voltage Rating (Drill)
18VDC
Battery Capacity
1000mAh
No-load speed
n
o
0-550min
-1
Chuck Capacity
0-10mm (drill); ¼” hex driver
Charging Time (typ)
3-5 hours