12
RSXM10a & RSXM12a Rear Panel Layout
1. XLR and ¼” INPUT Connector
-
This combo XLR and ¼”
connector accepts either a
balanced or unbalanced line
level signal. The ¼” phone
input accepts TS or TRS type
connectors.
2. LINE Output -
Male XLR connector
used to link multiple speaker
cabinets.
NOTE: When connecting a
loudspeaker to the Line Output
of the RSXM loudspeaker, it is
important to power on the RSXM
loudspeaker first, then power
on the linked speaker. When
powering down the system, it is
recommended to turn off all linked
speakers, then power off the RSXM
loudspeaker.
3. VOL Control -
This volume
knob adjusts the level of the
loudspeaker.
4. MONITOR/FOH Switch -
This switch sets a specific equalization curve for the stage monitor position
or for use as a front of house speaker.
5. SIGNAL/LIMIT Indicator -
This bi-color LED lights GREEN when signal is present at the inputs,
regardless of the input volume control settings. The indicator lights RED when the amp is near
the clipping point and the limiter is engaged. If the LIMITER indicator lights frequently, turn
down the INPUT volume controls on the speaker or turn down the signal at the source, until the
indicator does not light anymore, or lights only occasionally with high signal peaks.
6. POWER Indicator -
The POWER LED lights indicating that the main POWER switch is on.
7. Power Switch -
This rocker switch turns on and off the speaker’s main power. The switch lights
RED when the amp is active.
NOTE: It is important to remember the Golden Rule of audio… “LAST ON, FIRST OFF.” Translated, this
means that when turning on your system, you should always turn your powered speakers on LAST, and
when turning your system off, turn your powered speakers off FIRST. This helps avoid any loud pops
caused by inrush current at power up, or down, which can sometimes damage loudspeakers.
8. AC Power Inlet -
Connect the supplied standard 3-prong IEC power cable here.
Note: Never disconnect the plug’s ground pin. It is dangerous and can result in electric shock!
9. Fuse Cover -
The fuse is located behind the fuse cover. Always replace fuses with the same type of
fuse.
Summary of Contents for RSX M10a
Page 1: ...OWNER S MANUAL ...
