C/ROOM + PHONES
The C/ROOM + PHONES control is used to set the level sent to the control room outputs, and also to
the headphone jack.
+48V - Phantom Power LED
The +48V LED illuminates indicating that the 48 volt
phantom power is applied to the microphone pre-
amps enabling use with condenser microphones.
The +48V LED will light up when the Phantom Power
switch (located on the rear panel) is switched to the
ON position.
POWER LED
The Power LED lights up to indicate that the main
POWER switch (located on the rear panel) is on.
Output Level Meter
The OUTPUT LEVEL METER allows you to monitor
the level of the signal which is being sent to the MIX
OUT jacks.
NOTE: To avoid distortion, adjust the L/R faders so
that the 0 indicator LED lights occasionally.
MIX/2T
The MIX/2T switch selects the signal source that you
are monitoring in the CONTROL ROOM and HEAD-
PHONE outputs. When the switch is in the up posi-
tion, the signal source is from the LEFT/ RIGHT MIX
bus. When the MIX/2T switch is in the down position,
the signal source is from the 2-TRACK input.
L MIX R
The master MIX level controls are the overall volume
control for the MIX bus. The MAIN level affects both
the Control room signal which is output to the speak-
ers and the line level signal which is output from the
MIX OUT jacks.
16
Controls and Functions
MASTER SECTION
14
18
_
_
_
_
_
_
_
_
_
_
_
_
_
_
_
_
MONO
AUX RETURN
C/ROOM
+PHONES
LEFT
RIGHT
LEFT
RIGHT
2T IN
2T OUT
MIX/2T
5
0
10
5
0
10
2TK TO RETURN
5
0
10
5
0
10
10
5
0
10
5
20
30
40
10
5
0
10
5
20
30
40
10
5
0
10
5
20
30
40
15
15
15
M A X I M U M D Y N A M I C R A N G E
HARD
DISK
MODE
MASTER SECTION
PEAK
+6
0
-6
-20
POWER
48V
19
17
17
15
14
15
16
18
19
9
Summary of Contents for MDR MDR 6
Page 23: ......