Samson EB 3773 Series, Mounting And Operating Instructions

Page: 21 / 68

EB 3773 EN 5-1
Installation
5 Installation
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
5.1 Installation conditions
Work position
The work position for the limit switch is the
front view onto the device cover seen from
the position of operating personnel.
Plant operators must ensure that, after instal-
lation of the limit switch, the operating per-
sonnel can perform all necessary work safely
and easily access the device from the work
position.
Mounting orientation
The limit switch may be installed in any posi-
tion.
5.2 Preparation for installation
Before mounting, make sure the following
conditions are met:
− The limit switch is not damaged.
Proceed as follows:
Î
Lay out the necessary material and tools
to have them ready during mounting.
Table 5-1: Accessories for attachment according to VDI/VDE 3845, level 1
Designation Order no.
Mounting kit for mounting on rotary actuator, 20 mm, fixing level AA1 100015897
Consisting of: 1x Mounting bracket VDI/VDE 3845, 20 mm shaft height 0300-1214
4x Cap screw ISO 4762, M5x12 8333-1249
4x Disk spring DIN 2093, B10, 1.4310 8392-0691
Mounting kit for mounting on rotary actuator, 30 mm, fixing level AA2 100015792
Consisting of: 1x Mounting bracket VDI/VDE 3845, 30 mm shaft height 0300-1330
4x Cap screw ISO 4762, M5x12 8333-1249
4x Disk spring DIN 2093, B10, 1.4310 8392-0691
Mounting kit for mounting on rotary actuator, 30 mm, fixing level AA4 100015889
Consisting of: 1x Mounting bracket VDI/VDE 3845, 50 mm shaft height 0300-1330
4x Cap screw ISO 4762, M5x12 8333-1249
4x Disk spring DIN 2093, B10, 1.4310 8392-0691