Samson AirLine SYNTH Owner'S Manual Download Page 4

PRECAUCION: Para reducir el riesgo de incendios o descargas, no permita que este aparato quede expuesto a la lluvia 

o la humedad. Para reducir el riesgo de descarga eléctrica, nunca quite la tapa ni el chasis. Dentro del aparato no hay 

piezas susceptibles de ser reparadas por el usuario. Dirija cualquier reparación al servicio técnico oficial. El símbolo 

del relámpago dentro del triángulo equilátero pretende advertir al usuario de la presencia de “voltajes peligrosos” no 

aislados dentro de la carcasa del producto, que pueden ser de la magnitud suficiente como para constituir un riesgo de 

descarga eléctrica a las personas. El símbolo de exclamación dentro del triángulo equilátero quiere advertirle de la exis-

tencia de importantes instrucciones de manejo y mantenimiento (reparaciones) en los documentos que se adjuntan 

con este aparato. 

Instrucciones importantes de seguridad

1.  

 Lea todo este manual de instrucciones antes de comenzar a usar la unidad. 

2.

Conserve estas instrucciones para cualquier consulta en el futuro.    

3.

Cumpla con todo lo indicado en las precauciones de seguridad. 

4.

Observe y siga todas las instrucciones del fabricante.   

5.

Nunca utilice este aparato cerca del agua o en lugares húmedos. 

6.  

 Limpie este aparato solo con un trapo suave y ligeramente humedecido. 

7. 

 No bloquee ninguna de las aberturas de ventilación. Instale este aparato de acuerdo a las instrucciones del fabri-

cante. 

8.

No instale este aparato cerca de fuentes de calor como radiadores, calentadores, hornos u otros aparatos (incluy-

endo amplificadores) que produzcan calor.  

9.

No anule el sistema de seguridad del enchufe de tipo polarizado o con toma de tierra. Un enchufe polarizado 

tiene dos bornes, uno más ancho que el otro. Uno con toma de tierra tiene dos bornes normales y un tercero para 

la conexión a tierra. El borne ancho o el tercero se incluyen como medida de seguridad. Cuando el enchufe no 

encaje en su salida de corriente, llame a un electricista para que le cambie su salida anticuada.  

10.

Evite que el cable de corriente quede en una posición en la que pueda ser pisado o aplastado, especialmente en 

los enchufes, receptáculos y en el punto en el que salen de la unidad.  

11.

Desconecte de la corriente este aparato durante las tormentas eléctricas o cuando no lo vaya a usar durante un 

periodo de tiempo largo.  

12.

Dirija cualquier posible reparación solo al servicio técnico oficial. Deberá hacer que su aparato sea reparado 

cuando esté dañado de alguna forma, como si el cable de corriente o el enchufe están dañados, o si se han der-

ramado líquidos o se ha introducido algún objeto dentro de la unidad, si esta ha quedado expuesta a la lluvia o la 

humedad, si no funciona normalmente o si ha caído al suelo.

ATTENZIONE: per ridurre il rischio di incendio o di scariche elettriche, non esponete questo apparecchio a pioggia o 

umidità. Per ridurre il pericolo di scariche elettriche evitate di rimuoverne il coperchio o il pannello posteriore. Non esis-

tono all'interno dell'apparecchio parti la cui regolazione è a cura dell'utente. Per eventuale assistenza, fate riferimento 

esclusivamente a personale qualificato. Il fulmine con la punta a freccia all'interno di un triangolo equilatero avvisa l'utente 

della presenza di "tensioni pericolose" non isolate all'interno dell'apparecchio, tali da costituire un possibile rischio di 

scariche elettriche dannose per le persone. Il punto esclamativo all'interno di un triangolo equilatero avvisa l'utente della 

presenza di importanti istruzioni di manutenzione (assistenza) nella documentazione che accompagna il prodotto.

Importanti Istruzioni di Sicurezza

1. Prima di usare l'apparecchio, vi preghiamo di leggerne per intero le istruzioni. 

2. Conservate tali istruzioni per una eventuale consultazione futura.

3. Vi preghiamo di rispettare tutte le istruzioni di sicurezza. 

4. Seguite tutte le istruzioni del costruttore.   

5. Non usate questo apparecchio vicino ad acqua o umidità. 

6. Pulite l'apparecchio esclusivamente con un panno asciutto.  

7.   Evitate di ostruire una qualsiasi delle aperture di ventilazione. Posizionatelo seguendo le istruzioni del costruttore. 

8.    Non posizionatelo vicino a sorgenti di calore come radiatori, scambiatori di calore, forni o altri apparecchi (amplifica-

tori compresi) in grado di generare calore.

9.    Non disattivate la protezione di sicurezza costituita dalla spina polarizzata o dotata di collegamento a terra. Una 

spina polarizzata è dotata di due spinotti, uno più piccolo ed uno più grande. Una spina dotata di collegamento a 

terra è dotata di due spinotti più un terzo spinotto di collegamento a terra. Questo terzo spinotto, eventualmente 

anche più grande, viene fornito per la vostra sicurezza. Se la spina fornita in dotazione non si adatta alla vostra 

presa, consultate un elettricista per la sostituzione della presa obsoleta.  

10. Proteggete il cavo di alimentazione in modo che non sia possibile camminarci sopra né piegarlo, con particolare 

attenzione alle prese, ai punti di collegamento e al punto in cui esce dall'apparecchio.  

11.    Staccate l'apparecchio dalla alimentazione in caso di temporali o tempeste o se non lo usate per un lungo periodo.  

12.   Per l'assistenza, fate riferimento esclusivamente a personale qualificato. È necessaria l'assistenza se l'apparecchio ha 

subito un qualsiasi tipo di danno, come danni al cavo o alla spina di alimentazione, nel caso in cui sia stato versato 

del liquido o siano caduti oggetti al suo interno, sia stato esposto a pioggia o umidità, non funzioni correttamente 

o sia stato fatto cadere.

Summary of Contents for AirLine SYNTH

























Reviews: