EB 2520 EN
9
Safety instructions and measures
NOTICE
!
Risk of regulator damage due to incorrectly attached slings.
Î
Do not attach load-bearing slings to the actuator housing.
Risk of valve damage due to unsuitable medium properties.
The valve is designed for a process medium with defined properties.
Î
Only use the process medium specified for sizing the equipment.
Risk of leakage and valve damage due to excessively high or low tightening
torques.
Observe the specified torques when tightening valve components.
Excessive tightening torques lead to parts wearing out more quickly. Parts that are too
loose may cause leakage.
Î
Observe the specified tightening torques.
Risk of regulator damage due to the use of unsuitable lubricants.
The lubricants to be used depend on the regulator material. Unsuitable lubricants may
corrode and damage surfaces.
Î
Only use lubricants approved by SAMSON.
When in doubt, consult SAMSON.
Risk of regulator damage due to the use of unsuitable tools.
Certain tools are required to work on the regulator.
Î
Only use tools approved by SAMSON.
When in doubt, consult SAMSON.
Risk of excess pressure damaging plant sections due to construction-related seat
leakage through the regulator.
Î
Always install a safety device (e.g. safety excess pressure valve or safety relief
valve) in the plant.
SAMSON's After-sales Service can support you concerning lubricant, tightening torques
and tools approved by SAMSON.
Note
Summary of Contents for 2405 Series
Page 36: ...36 EB 2520 EN Certificates...