DAS
Switchers
Sams elektronik d.o.o. • [email protected] • www.sams.rs
elektronik
13
NETWORK ACCESS AND DEVICE CONTROL
The device can be configured through the web browser. First, the device must be found in the local
network. To do this, start the Sams Netfinder software double clicking on the icon. The software first
scans for devices.
Sams Netfinder: scan for devices
When the search is completed, a new window will open showing found devices.
NETWORK SETUP
To change the settings, consult your network administrator.
The default IP address is 192.168.0.200. If there is a DHCP server, the device will be assigned a new
address.
If there is a problem with connecting the device, check the firewall and allow UDP port 3040.
Sams Netfinder: found devices
Click on the desired device and press the “Web Browser” located on the left side of the software.
Browser will display the configuration options.
NOTE:
The device will be found from across the network only if the device was connected to a network cable
before turning on.
If the program NETFINDER does not find the device on the network, try the following:
- Connect the inserter directly to the computer;
- The computer set with fixed IP address, as follows:
IP ADDRESS 192.168.0.15
SUBMASK IP 255.255.255.0
IP GATEWAY left blank;
- Set REPAIR network card, in order to fully accept the new settings (alternatively RELEASE / RENEW
scenario);
- Try NETFINDER;
- The device must be seen;
- Write down the MAC ADDRESS and consult with the network administrator.
NOTE:
Do not use simultaneously with multiple places control over the network!
Just enter the correct value in the permitted range.
The manufacturer does not guarantee the validity of the results of irresponsible use of the device.
