8x8
Sams elektronik d.o.o. • [email protected] • www.sams.rs
elektronik
15
Routing switchers
REMOTE
www.sams.rs
Made in Serbia
SN:
ADDRESS:
SLAVE REMOTE FOR:
32x32
NO USER - SERVICEABLE PARTS INSIDE!
REFER SERVICING TO QUALIFIED PERSONNEL!
16x16
64x64
OTHER
UNDO LOCK PANEL
LOCK
INPUTS
REMOTE
VIDEO
AUDIO 2
AUDIO 1
Remote control panel 8x1
CP-8
www.sams.rs
S
O
U
R
C
E
S
O
U
R
C
E
PC
1
3
5
7
2
4
6
8
VIDEO
AUDIO 1
AUDIO 2
UNDO
LOCK
PAN. LOCK
CP-8 is slave remote control for routing switchers 8x8.
Connect slave command to master. Press and hold button PANEL LOCK for a few seconds. While hold
PANEL LOCK select the desired destination by pressing the source (SOURCE). Make sure that the
selected destinations do not match with already selected on the master or another previously set slave
commands. Pressed keys will start blinking. In this way, you will notice that the selected destinations will
be used only to this command. Select one destination. After selecting release PANEL LOCK key.
LOCK
Use this option when you want to lock destination. To lock the destination, press and hold the desired
destination it then press LOCK. In the same way, it unlocks the destination. From that moment that
destination button flashes, which indicates that it is locked. On that destination nothing else can be
brought as a source until destination is unlocked.
UNDO
Use this option if you want to restore the previous state of the connection. Since this type of commands
uses only one destination if UNDO button is illuminated, then it is possible to return to the previous
state of the connection. UNDO option saves only one step in all three levels (Video-Audio1-Audio2) and
each level can be called independent. UNDO option may not be called if the routing switcher powered
on for the first time. Remote control saves the previous state connections in the event of a power failure
or deliberate shutdown. In a system where two or more commands can control the same destination,
return to the previous state can be made with any such command.
PANEL LOCK
Use this option when you want to lock the entire panel. In this case, the control of the routing switcher
takes the PC. When PANEL LOCK is off, the software on the PC is used only for monitoring and PC
ENABLE LED flashes.
PC ENABLE
LED flashes when the PC software is active.
INPUTS - source keys
OUTPUTS - destination keys
VIDEO - control of video router
AUDIO 1 - control of audio 1 router
AUDIO 2 - control of audio 2 router
UNDO - one step back
LOCK - destination lock
PANEL LOCK - remote control lock
REMOTE - connection to master remote control
CP-8, SLAVE REMOTE CONTROL 8X1
