www.larius.com
3
VEGA 13:1
REV.
01 - 06/2020 - Cod. 150143
B
C
Parts of the pump in contact with the material
Pumping group: galvanized carbon steel
Sealing balls: stainless steel AISI 420B
Gaskets: PTFE, Viton
Other parts of the pump
Motor casing and motor piston: aluminium
Always observe these instructions carefully
when evaluating the product compatibility and
in case of disposal of some parts of the pump no
more usable, in order to meet the environmental
regulations on recycling process.
*N.B.
The pump is supplied with a bayonet connection.
WORKING PRINCIPLE
VEGA 13:1
is a medium pressure pneumatic pump used for
extrusion and transferring of high viscosity products.
The pump is essentially constituted of an air motor and of a struc-
ture called "material pumping group" or simply "pumping group".
In the pneumatic motor, compressed air causes the vertical
reciprocating movement of the motor piston; this movement is
transmitted through a connecting rod to the material pumping
piston ending with a shovel plate alowing to suck very viscous
products.
The ratio 13:1 means that the outlet pressure of material is 13
times higher than the pump feed air pressure.
TECHNICAL DATA
VEGA 13:1
Pump feed air pressurea
3-7 bar
Maximum pressure of the product
91 bar
*Feed air inlet
3/8" GAS (F)
Maximum delivery
4 l/m (6,4 cpm)
Cycles per litre
15
Maximum cycles per minute
60
Material outlet [conical gas(f)]
3/4" GAS CON. (F)
Noise pressure level
<80 dB (A)
