Samlexpower Evolution Series, Quick Start Manual, Page: 7 / 12

6 | SAMLEX AMERICA INC. SAMLEX AMERICA INC. | 7
7. Determine whether the optional EVO-RC remote control is necessary for
your application
• The EVO-RC provides useful functional information such as battery voltage, battery
charging status, and AC output power. The EVO-RC is also capable of logging events to
an SD card to create a history record of usage and performance.
• The EVO-RC is required to adjust any of the programmable parameters to customize
its functionality to your specific requirements. Please refer to the EVO-RC Owner’s
Manual for all programming instructions.
• If the factory defaults are adequate for your requirements or once parameters are
adjusted to meet your requirements, it is not necessary to keep the EVO-RC attached
to the EVO
TM
Inverter Charger to maintain functionality.
• If the user would like to have the EVO-RC installed, there is a 1:1 wall cutout template
in the EVO-RC box for a flush mounted installation with basic installation instructions.
WARNING!
If there are any items in Sections 1, 2 or 3 of the EVO
TM
Owner’s Manual that you do not understand, do not
attempt to install the unit yourself. For a safe and code compliant installation, please consult a Certified
Electrician that is familiar with Local and National electrical codes.
All electrical systems both DC and AC must be disconnected from the source during the installation. Use of
isolated tools is recommended.
8. You are now ready to install the EVO
TM
Inverter Charger
• Re-read Section 3, starting the EVO
TM
Owner’s Manual
• Mount the EVO
TM
in the planned location
• Mount, cable, and attach the optional EVO-RC if desired
• Install AC Input and AC output wiring and breakers
• Install the battery bank in the planned configuration
• Connect the battery bank to the EVO
TM
Inverter Charger
• Recheck all wiring, grounding, and connections
9. If all wiring, grounding, and connections are correct, complete the installation
• Tighten cable glands
• Install DC terminal covers
• Replace AC access cover
• Place DC fuse in fuse holder. When placing this fuse a spark can occur.
• Switch on the DC
• Switch on the AC
10. Switch on the EVO Inverter Charger.
• Press and hold the ON/OFF Button.
• Green LED labeled “ON” will flash 3 times, will go off momentarily, then resume
ON steady. Now release the ON/OFF Button (This procedure takes around 2 sec).
• If the EVO does not start immediately, switch OFF the DC and AC power.
EVO
TM
INVERTER/CHARGER | Quick Start Guide