16
5.2.2 Installation
• Ensure approximately 49mm width, 49mm height and 23mm depth for the take-up of the
remote controller (see Figure 14 Remote Controller RC-600, Page. 8).
• Connect the remote control to the charger. The connection cable is equipped with two
equivalent modular plugs.
• Place the remote control into the opening created. Secure the remote control with screws
on the upper and bottom margin of the faceplate – use the available drills.
Note
The length of RC-600 cable is 10M.
Note
The power switch at the unit must be switched ON, so that the unit can be switched ON and OFF with
the remote control.
5.3 Remote Controller RC-601D
The remote controller RC-601D,
Figure 15 Remote Controller RC-601D, Page. 9) displays real-time information, settings and count down
for different charging stages.
5.3.1 Functions
• Switch the charger ON and OFF.
• Half power mode ON / OFF.
• Equalization ON.
• Display real-time information and settings.
Note
The power switch at the charger must be switched ON, so that the charger can be switched ON and OFF
by the RC-601D remote controller.
Caution!
Be careful when attaching the remote control, for wiring harnesses, cables and other components that
are in the assembly range could be damaged in the process!
5 Accessories
ENG
Summary of Contents for WSC-1230
