Doc.-ID: 190314-PT08BA-ES-ExCam XF-P1367_EN_rev.00.docx, Page 10 of 32
Wiring table:
Potential
Colour (IEC 60757)
Cross-
section
Comment
PA
GN/YE
4 mm
2
(rigid)
Terminal: slotted screw M4x0.7 (DIN 84) with
washer Ø9mm (DIN 125A),
Keep 3Nm tightening torque!
Tab. 5-1 Equipotential Bonding
5.2
Connection and Fusing
Fig. 5-2. Cable gland (KLE) and supply line
The green system cable is intended for communication and data transfer to the connect-
ed network devices and, at the same time, for voltage supply (PoE) to the camera. To
ensure the power supply of ExCam XF P1367 (
Powered Device
/ PD), it is necessary to
make sure that the power-over-Ethernet provider (
Power Sourcing Equipment
/ PSE) on
the connection side (for example PoE Midspan PoE injector, switch, etc.) fulfils the speci-
fication IEEE 802.3af and 802.3at type 1 Class 3
("classification current: 26-30 mA
@48VDC, max. feed-in power (power source equipment): 15.4 W, maximum offtake
(power device): 6.49 - 12.95 W"
). The data transfer of the ExCam XF P1367 series is
done via a 100 Mbit/s Ethernet connection (100BASE-TX).
Fig. 5-3. ExCam XF P1367 T08-VA2.3.K3.BOR2-LL.H-005.N-
P
Cable gland flange 1F, type 6, M20
SKDP03-T - digital video stream
Control system and power supply
(PoE) of the camera module
