Operating instructions for SAMBO Bevel
V1.00-2021.03.22
SEC-DS-ENGLISH-GETRIEBE-SAMBO-Kegelrad-V1.00-2021.03.22
Operating instructions for SAMBO SB-V series bevel gear operator
1
Introduction
This installation and maintenance manual explains, how to install and maintain the Sambo SB-V operator.
Information on installation, disassembly, reassembly, lubrication and spare parts is provided.
Figure 1:
V Exploded View
Figure 2:
VH Exploded View
WARNING: Do not manually operate the SB-V(H) gearbox (see figures 1 and 2) with devices
other than the installed handwheel or wrench nut. Using additive force devices (cheater bars,
wheel wrenches, pipe wrenches, or other devices of this nature) on the gearbox handwheel,
wrench or wrench nut may cause serious personal injury and/or damage to the gearbox or valve.
2
Safety instructions
NOTE:
Read this Installation, Operation and Maintenance manual carefully and completely before attempting
to install, operate or troubleshoot the SAMBO gearbox.
CAUTION:
Work undertaken must be carried out in accordance with the instructions in this and any
other relevant manuals. The user and those persons working on this equipment should be familiar
with their responsibilities under any statutory provisions relating to the Health and Safety of their
workplace. Due consideration of additional hazards should be taken when using the gearbox with other equip-
ment. Should further information and guidance relating to the safe use of the SAMBO products be required, it
will be provided on request.
NOTE:
The mechanical installation should be carried out as outlined in this manual and also in accordance
with relevant standards. No inspection or repair should be undertaken unless it conforms to the specific haz-
ardous area certification requirements. For maintenance of the actuator, refer to the actuator installation and
maintenance manual.
1