SaMASZ XT 390, Operator'S Manual, Page: 25 / 48

25
OPERATOR'S MANUAL REAR DISC MOWER XT
Fig. 17. Taking turns over swaths
5.3. Preparing the mower to transport
Preparation of the front-rear flail mower mounted on the tractor for transport - movement on
public roads - requires the following:
❑
lift the mower with tractor hydraulic lift onto the tractor links until pins of the mower 3-point linkage
are min. 500 mm (
dimension Y ) above the ground ( Fig. 20 ),
❑
lift the support legs W ( Fig. 18 ) and secure them with cotter,
❑
fold side safety curtain to reduce the total transport height ( Fig. 20 ),
❑
using hydraulic cylinders lift the cutting unit to vertical position until mower arm connector lies on
the body connector (
Fig. 19 - Fig. 20 ),
❑
the mower is equipped with transport lock as pin S ( Fig. 19 ). Secure the cutting unit against falling
by pushing the pin through and securing it with cotter,
❑
lower the transport height on tractor's links individually depending on the mower and tractor model
to
Tab. 5 so it is no greater than 13′ 1″ ( 4.0m) ( Fig. 20 ).
❑
when setting min./max. height on tractor's lower links pay particular attention to drive shaft
B ( Fig. 11 ) connecting the mower to the tractor's PTO. If the mower is lowered or lifted too much,
the PTO shaft may be damaged.
Fig. 18. Support legs Fig. 19. Transport lock
W
S
STOP