Operator’s manual
Bale wrapper
Spin
- 12 -
6.1. Commissioning of the counter
Connect the counter to the revolution sensor using the attached cables. Lightly press and
hold (for about 4 second) the C button. The button needs only to be pressed with the tip of the
finger. The counter button is placed under an elastic membrane.
When turned on, the counter indicates “0”. Lightly press and hold (for no longer than 3
seconds) the ON button. The number 16 will appear, denoting the number of bale wraps. Release
the button. The indication tops blinking.
Press the button again (hold for not longer than 3 seconds) to change the number of wraps.
Holding the button longer with the set number of wraps until the display shows “0” will result in
recording the set number of wraps by the counter. The counter is ready to work.
Lightly press and hold (for about 4 seconds) the C button. The counter will be turned off
after about 6 minutes of inactivity, i.e. when it no longer receives impulses from the sensor and any
signals from the C button.
Protect the counter against humidity, excessive vibration and hitting the cabin elements and
especially against falling on a hard surface. The meter can be fixed using its back surface catch.
If the counter is fouled, clean it using a damp cloth with a mild detergent. Do not use
organic solvents for cleaning (acetone, gasoline, “nitro“ solvent etc.) as the counter‘s casing may be
damaged.
NOTE!
Protect the meter from water, chemical agents, direct atmospheric
precipitation frost, high temperature in excess of 50°C and direct exposure to
sunlight.
7.
CONTROLS AND ONGOING ADJUSTMENT
7.1.
Location of the controls
NOTE!
Operate the machine from inside the tractor’s cabin using the tractor’s
hydraulic controls.
The location of the hydraulic controls is specified in the tractor operating manual.
