Operator's Manual
Truck Snow Plow
SnowPick
-
18
-
Instructions for controller operation:
1.
The controller starts automatically after turning the ignition key.
2.
To move the shield UP/LEFT/RIGHT push
,
,
button respectively (also it can be
pushed quickly twice).
3.
To
LOWER
the
shield
push
and
hold
button
(also it can be pushed quickly twice).
4.
To turn on the FLOATING function push button
, and then push
again and hold it. The
option will become activated for 1-29mins (default 20 min). The option can be cancelled by
pushing
.
5.
Snow removal AUTO. To activate this function push button
AUTO
, and then
/
respectively. This enables snow removal in two work modes:
•
Pulling snow to the rear. The shield will lower automatically, if the reverse gear is engaged
in the vehicle. The shield will raise automatically, if the reverse gear is disengaged.
•
Pushing snow to the front. The shield will lower automatically, if the reverse gear in the
vehicle is engaged. The shield will raise automatically, if the reverse gear is engaged.
•
The AUTO mode will become deactivated after button
AUTO
is pressed and released, to
indicate this LED (C) (Fig. 16) will go out.
After buttons
/
/
are pushed quickly the hydraulic power supply motor will
operate for 1s. This is meant to reduce power consumption, so that after the button is pushed twice
the motor is not started twice. This would cause faster wear of the plow's motor pump and
consumption of vehicle's battery.
While the plow SnowPick is transported and operated make sure its support feet are lifted.
Also turn off the vehicle's assembly lighting. Check whether the clearance between bumpers is kept
(Fig. 12), otherwise loosen the chain.
