Instruction manual
Rear - front and rear flail mowers
MIDO, GRINO, VINO, MAMUT
-
26
-
6.3.4. Everyday maintenance
The following should be done everyday after finishing work:
wash the mower removing any remains of dirt or vegetation,
check all visible external parts and assemblies and their connections,
tighten all loose bolt connections and replace all worn or damaged parts,
lubricate the telescoping shafts of the ATS with an STP grease,
if necessary lubricate all other assemblies in accordance with lubricating instructions (point 0),
lubricate the bearings on both sides of the flailing shaft using ŁT 43 grease,
check for any play within the bearings of the copying and flailing shafts. In the event of any
play replace the bearings.
6.3.5. After-season maintenance and storing
After the end of mowing season the mower should be carefully cleaned and washed and after
drying all working surfaces and suspension pins should be protected from rust by lubricating with
grease.
Additionally:
touch up any chips in the paint
,
check the oil levels in the gearbox,
examine technical condition of the copying and flail shaft’s bearings. If necessary replaced
bearings and seals (execution of the activity by experts from SaMASZ company),
protect working parts (pins, joints, cylinder rods, etc.) against corrosion by applying a thin film
of solid grease on their surfaces.
Dismounted mower should be stored in its parking position, so it is set stabile on slides and on
the ground shaft. It is recommended, to store the machine on paved ground, preferably under the
roof, inaccessible to unauthorized personnel (especially children). The machine should be stored in
a dry place, in case of wet weather recall that the machine should be greased properly.
6.3.6. Restarting the machine after storing period
After the storing period perform the following:
Make sure that all nuts and screws are tightened with correct torque (
Tab. 9
).
Make sure that all guards are installed in place.
Lubricate the whole machine.
Examine condition of flail knives, and if necessary, replace them with new ones.
