9
OPERATOR’S MANUAL
REAR DISC MOWER
KDT
3-point linkage frame (
1)
enables attachment of the mower to tractor’s 3
-point linkage. Drive from
tractor’s rpm is transmitted through intersecting axis gear (
3
) on the cutterbar (
4)
. On the cutterbar,
there are discs with two knives each. Apart from that, drive from tractor’s rp
m through
V-belt drive
(
8
)
and PTO shaft (
9
) is transmitted to tine conditioner (
7
). Hydraulic cylinder (
2)
is used to adjust
the mower to working position. It is supplied from outer hydraulics of the tractor. Main frame, on which
the cutterbar (
4
) is situated, is supported by the springs (
2
). Swath guides (
5)
are mounted on the safety
curtain (
6
).
3.3.1.
Rear disk mower with roller condioner
Fig. 3c.
Parts of SaMASZ rear disc mower with tine conditioner
1
–
3-point linakge frame
2
–
Hydraulic cylinder with support springs
3
–
Axis gear
4
–
Cutterbar
5
–
Swath guides
6
–
Roller condioner safety guard
7
–
Roller conditioner
8
–
V-belt drive
9
–
Roller condioner PTO shaft
10
–
Support legs
3-point linkage frame (
1
)
enables attachment of the mower to tractor’s 3
-point linkage. Drive from
tractor’s rpm is transmitted through axis gear (
3
) on the cutterbar (
4
). On the cutterbar, there are discs
with
two knives each. Apart from that, drive from tractor’s rpm through
V-belt drive
(
8
) and PTO shaft
(
9
) is transmitted to roller conditioner (
7
). Hydraulic cylinder (
2
) is used to adjust the mower to working
position. It is supplied from outer hydraulics of the tractor. Main frame, on which the cutterbar is
situated, is supported by the springs (
2
). Swath guides (
5
) are mounted on the safety guard.
3.4.
Equipment and spare parts
The mowers are sold with the following standard equipment:
❑
warranty card,
❑
operator's manual with catalogue of spare parts and declaration of conformity,
❑
cutting knives (additional set),
❑
frame mounting key,
❑
PTO shaft,
❑
spray paint (150 ml / 5.3 uk fl oz).
Optional extra equipment:
❑
warning triangle,
❑
topping plates / double topping plates,
❑
cutting disc with instep (set),
❑
double swath guide (only KDT 341),
❑
two swath cutterbar configuration (only KDT 341).
1
2
3
4
5
7
8
9
10
