15
OPERATOR’S MANUAL
REAR DISC MOWER
KDT
Fig. 6.
Location of centre of gravity on mowers KDT
Tab. 4.
Location of centre of gravity
Dimension
[mm]
Model
KDT 180 KDT 220
KDT 220
S
KDT 220
W
KDT 260
KDT 260
S
KDT
260 SL
KDT 260
W
KDT 300 KDT 340 KDT 341
A
2
′ 5″
2
′ 4″
2
′ 9″
2
′ 9″
2
′ 8″
2
′ 8″
2
′ 8″
2
′ 9″
2
′ 4″
2
′ 4″
B
5″
1″
4″
5.5
″
6.3
″
8″
8.7″
8.7″
1′
1
′ 7″
C
2
′ 9″
3
′ 2″
3
′ 4″
3
′ 6″
3
′ 4″
3
′ 5″
3
′ 4″
3
′ 7″
3
′ 5″
3
′7″
4.5.
Working parts
❑
Before
operating the mower check knife’s and knife holder’s condition.
❑
Worn or damaged knives or knife holders should be immediately replaced with new one.
❑
During replacement of working parts, it should be used personal protective gloves.
4.6.
PTO shaft
❑
Before operating, read bar manufacturer's manual placed on the bar. Follow all safety precautions
in that manual.
❑
Use only PTO shafts recommended by mower’s manufacturer with guards in good condition.
❑
In order to operate safely, use only undamaged PTO shafts and shields. Damaged PTO shafts and
shields must be repaired or replaced with new ones before use.
❑
Before any operation make sure whether PTO rpm have proper rotational direction.
4.7.
Hydraulic assembly
❑
Hydraulic assembly is under high pressure. Hydraulic oil under pressure may penetrate skin and
cause serious injury or death. Skin and eyes should be protected when working around this
assembly.
❑
In case of injury caused by a liquid under pressure, call a doctor immediately.
❑
Hydraulic hoses can be
connected to the tractor's hydraulics provided that both the tractor’s and
the mower's hydraulic assemblies are not under pressure. To remove the pressure from the hoses,
start the tractor's hydraulic valves several times with the tractor off.
❑
When looking for oil leaks, do so safely. Use a cardboard card. Do not touch any potential leaks
until the entire hydraulic assembly has been relieved of pressure.
