Operator's manual
TREE STUMP GRINDER
FP 20
-
10
-
Fig. 3. Tree stump grinder FP 20
–
0.4 m
Description of branch grinder and working principle.
A. – Mounting plate.
E. – Hydraulic engine.
B. – Grinder housing.
F. – Nozzles of hydraulic hoses.
C. – Cutting disk.
G. – Support leg.
D. – Cutting knife with knife holder.
H. – Rubber guard.
Fig. Hydraulic scheme
Fig. 3.1. Hydraulic scheme
3.2
Control
Tree stump grinder is controlled with the extension arm control panel.
3.3
Transport position and drives
Transport position of tree stump grinder aggregated with SaMASZ extension arm corresponds
to the arm's transport position. See
Fig. 4.
When mounting the tree stump grinder on other type of extension arm, fold the tree stump
grinder aggregated with the arm in the position as compact as possible.
•
To transport the aggregation of arm and grinder, use any protective means as intended for control
and design of the extension arm.
•
Dismount the PTO shaft for transport. Provide proper marking and lighting of the aggregated
machines for a low-speed vehicle to comply with road traffic provisions.
•
Driving speed should always be adjusted to current road conditions.
F
H
G
C
D
E
A
B