Sam4s ER-5100? SERIES, Service Manual, Page: 21 / 80

5 Alignment and Adjustments
5-2 SAM4S ER-5100 SERIES
The relationship between the Adjustment Scale and the
paper remnant remaining on the core is as shown in
figure 5-3.
Remnant of (m):
#1 #2 #3 #4 #5
Figure 5-3. Relationship: Adjustment Scale to
Remnant Length
Note: figure 5-3 applies only when using SAM4S
recommended papers.
Figure 5-4 shows the relationship between the
Adjustment Scale and the outer diameter of the
Winding Core.
Adjusting Scale:
10 15 20 25 30
Outer diameter of paper winding core (
Φ :mm )
D: Outer Diameter
d: Inner Diameter
Figure 5-4. relationship: Adjustment Scale to
Winding core diameter
Note:
1. When using roll paper other than SAM4S
recommended paper, the roll paper remnant
lengths will differ.
2. When using roll paper with a red end mark, the
Winding Core may pull out of its holder due to the
paper sticking to Winding Core, If the Winding
Core pulls out of its holder, the Paper Sensor may
indicate an inaccurate remnant length.
5-1-3 Clearing a Paper Jam
5-1-3-(a) Paper Jamming Causes
1. When more than two papers have entered the
paper path.
2. When paper cutting remnants remain in the
paper exit space.
5-1-3-(b) Clearing Procedure
Caution:
Always disconnect the power cord from
the power outlet before working on the
Paper Cutter.
1. Open the Printer cover and remove the Auto-
Cutter Cover 2.
2. Remove all jammed paper at the Auto-Cutter.
3. Replace Auto-Cutter Cover 2 and close the
Printer cover.
4. The Auto-Cutter will operate as soon as power
is restored to the ECR. After cutting once, the
Auto-Cutter goes to its normal state.
#5
#4
#3
#2
#1
5
4
3
2
1