SAM4S ER-180T SERIES
3-1
3 Installation and Operation
WARNING:
Before using Electronic Cash Register (ECR) for the first time, leave it powered ON in the
REG mode for
at least 24 hours.
This allows the MS-Lithium battery, which maintains
the ECR’s memory while the power is OFF, to charge fully.
3-1 Installation
3-1-1. Paper Roll Installation and Take-Up Spool Installation
1. Remove the printer cover.(Fig 3-1 (A),(B))
2. Open the housing clam cover and Insert the paper roll as shown.(Fig 3-1 (C), (D))
3. Pressing the housing clam cover.(Fig 3-1 (E))
4. Lay a cover on the side and press the FEED button.
5. Feed the leading edge of the paper in about 150mm and fold the tip in 20mm.
Insert the leading edge of the paper into the slot on the Spool Winding. (Fig 3-1 (F),(G))
6. Turn the Spool Winding in 2~3 turns. (Fig 3-1 (H))
7. Place the Spool Winding on the Paper Supply. If it loosen, turn to tighten it. (Fig 3-1 (I))
8. Replace the printer cover.(Fig 3-1 (J))
Figure 3-1. Paper Installation and Take-Up Spool Installation
Summary of Contents for ER-180T
