-4-
-5-
-6-
To insert power wire and connect the 12 to 60 V DC at a
maximum of 1.5 A DC power to the power terminal block, follow
the steps below:
• Use flat-head screw driver to loosen the wire-clamp screws
• Insert the negative/positive DC wires into the PWR-/PWR+
terminals, respectively
• Tighten the wire-clamp screws to prevent the wires from loosen-
ing
!
ATTENTION:
Please use a power supply from 12 to 60 V DC, the
device power shall be supplied by SELV circuit.
!
ATTENTION:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received
including interference that may cause undesired
operation
!
ATTENTION:
If the equipment is used in a manner not specified by
SALZ Automation, the protection provided by the
equipment may be impaired.
Connect one end of an Ethernet/RJ45 cable into Ethernet port
of SWITCH 2016GT and other end to attached networking
device.
• Ports 1-16 of the switch support Fast Ethernet as well as
Gigabit Ethernet (10/100/1000Base-T RJ45 Ports)
• All the RJ45 ports on the SWITCH 2016GT support auto
negotiation and auto MDI/MDI-X to eliminate the need for
crossover cabling
5.3 Cabling RJ45
Address of the manufacturer:
SALZ Automation GmbH
Max-Planck-Str. 64
32107 Bad Salzuflen, Germany
Email: [email protected]
Please scan for more information:
v0.2
Note: Category 5e cable or above should be used.
Operating Temperature
-40˚C ... 70˚C
Storage Temperature
-40˚C ... 85˚C
Altitude
Up to 2000m
Ambient relative humidity
5 to 95% (non-condensing)
UL61010
Indoor use and pollution degree 2
6. DIP Switch Setting
8. Environmental limits
7. LED Indicators
PWR
(Green)
Power On by terminal block PWR or
DC-Jack
Terminal block PWR/DC-Jack fails or
is not available
RPS
(Green)
Power On by terminal block RPS
Terminal block RPS fails or is not available
PWR/RPS fails or not available
No alarm
LNK/ACT
(Green)
Copper port link-up 1000Mbps
Data is transmitting / receiving
Port disconnected or link failed
Illuminated
Illuminated
Illuminated
ALM
(Red)
1000M
(Green)
Off
Off
Off
Illuminated
Off
Illuminated
Blinking
Off
Link speed at 10/100Mbps
Link speed at 1000Mbps
The SWITCH 2016GT has one set of relay alarm output. This
relay contact uses two contacts of the terminal block on the
top panel.
The two contacts of the 6-pin terminal block connector are
used to detect user-configured events. The two wires attached
to the fault contacts form an open circuit when a user-config-
ured event is triggered. If a user-configured event does not
occur, the fault circuit remains closed.
Relay rating: 24V, 1A
5.2 Wiring the relay contact (ALM)
ON : Primary power alarm reporting is enabled
OFF : Primary power alarm reporting is disabled
ON : Redundant power alarm reporting is enabled
OFF : Redundant power alarm reporting is disabled
ON
OFF
ON
PWR
RPS
PWR
RPS
Load
External
Power
