-4-
-5-
-6-
To insert power wire and connect the 12 to 48 V DC at a
maximum of 1.5 A DC power to the power terminal block, follow
the steps below:
• Use flat-head screw driver to loosen the wire-clamp screws
• Insert the negative/positive DC wires into the PWR-/PWR+
terminals, respectively
• Tighten the wire-clamp screws to prevent the wires from loosen-
ing
!
ATTENTION:
Please use a power supply from 12 to 48 V DC, the
device power shall be supplied by 61010-2-201 R/C
power with SELV, Limited energy output.
!
ATTENTION:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received
including interference that may cause undesired
operation
!
ATTENTION:
If the equipment is used in a manner not specified by
SALZ Automation, the protection provided by the
equipment may be impaired.
Connect one end of an Ethernet/RJ45 cable into Ethernet port
of SWITCH 2016GT-E and other end to attached networking
device.
• Ports 1-16 of the switch support Fast Ethernet as well as
Gigabit Ethernet (10/100/1000Base-T RJ45 Ports)
• All the RJ45 ports on the SWITCH 2016GT-E support auto
negotiation and auto MDI/MDI-X to eliminate the need for
crossover cabling
5.2 Cabling RJ45
Address of the manufacturer:
SALZ Automation GmbH
Max-Planck-Str. 64
32107 Bad Salzuflen, Germany
Email: [email protected]
Please scan for more information:
v0.2
Note: Category 5e cable or above should be used.
Operating Temperature
-40˚C ... 75˚C
Storage Temperature
-40˚C ... 85˚C
Altitude
Up to 2000m
Ambient relative humidity
5 to 95% (non-condensing)
UL61010
Indoor use and pollution degree 2
7. Environmental limits
6. LED Indicators
PWR
(Green)
Power On by terminal block PWR or
DC-Jack
Terminal block PWR/DC-Jack fails or
is not available
LNK/ACT
(Green)
Copper port link-up 1000Mbps
Data is transmitting / receiving
Port disconnected or link failed
Illuminated
1000M
(Green)
Off
Illuminated
Off
Illuminated
Blinking
Off
Link speed at 10/100Mbps
Link speed at 1000Mbps
