Introduction
This smart energy plug-in switch is a transceiver which is compatible with
Salusfin Home Gate.
Remote On/Off control of the connected load can be done from Salusfin Mobile
Application. Each switch is designed to act as a repeater. Repeaters will re-
transmit the RF signal to ensure that the signal is received by its intended
destination by routing the signal around obstacles and radio dead spots.
This smart energy plug-in switch is able to detect voltage, current, power factor,
Instant power wattage (5~3150W) and overload wattage (3010~3300W) of
connected light or appliances. When detecting overload state, the Module will be
disabled and it’s On/Off button will be lockout of which LED will flash quickly
for 30 seconds. However, unplug and re-connect the Module will reset its
overload condition to normal status.
This plug-in switch can active sent out instant power wattage when variation
over 5% or active sent out state change when manually push the ON/OFF button,
this allows the controller to avoid polling the reading wattage value and state of
the switch and can increase the efficiency of controller.
Features
•
Adopt Z-Wave protocol to secure the success of wireless two way
communication
•
Higher RF output power (+2.5dBm output power as compared to 2.5dBm
300 series Z-wave module) to enhance the communication range
•
With zero crossing technology to extend the number of switching
•
Easy install
•
Very low Electricity consumption
•
Overload protection
