44
Chapter 10 Operation Faults and Solutions
10.1 Excessive Splicing Loss and Solutions
Image
Definition
Reason
Solution
Fiber core axial
deviation
There is dust on the
V-groove or fiber clamp.
Clean V-groove and
fiber clamp.
Fiber core angle
error
1) There is dust on
V-groove or fiber clamp.
2) Poor quality of fiber
end face.
1) Clean V-groove and
fiber clamp.
2) Check the fiber
cleaver working state.
Fiber core
bending
1) Poor quality of fiber
end face.
2) Low discharging
strength or short
discharging time.
1) Check the fiber
cleaver working state.
2) Enlarge [discharging
strength] and/or
[discharging time].
Fiber diameter
mismatch
Discharging strength too
low.
Enlarge [discharging
strength] and/or
[discharging time].
Summary of Contents for SFS-7000 Series
