Tel: 886.909 602 109 Email: [email protected]
10
after continuous operation of 12 months. The times of charging and discharging of the battery can be up
to 300-500, but it will lose its utility in the end. The battery must be replaced if its operation time is
obviously shorter than the normal one with full capacity.
4
Battery maintenance
Take the battery out and store it separately if it will not be used for a long time, conduct discharging and
charging on the battery once every 3 months, and ensure the capacity of the battery of 60% - 70% of the
full one, so as to guarantee the battery life. If the battery capacity can be used up before being charged
again, it can be used for longer time with sound performance.
5
Other battery information
a) Disconnect the adapter from the power supply when it is not used.
b) Charge the battery with the specified or certified charger with charging time of not more than 24
h, so as to ensure the normal battery life.
c) Battery with full capacity will be discharged automatically if it has not been used for a long time.
The capacity and life of the battery shall be decreased if it is stored at the place with too low or
too high temperature. The battery discharges fast when the outside temperature is high.
d) Frequent (regular) discharging can improve the battery performance and prolong its operation
life.
e) Do not wind wires on both ends of the battery.
f)
Stop to use the battery in case of any odor, discoloration, distortion, or other abnormality
occurred during the usage, charging and storage of the battery.
g) Never let the battery polarity short-circuit or affected with damp, so as to avoid any danger.
h) Do not drop the battery, cut it off or try to disassembly it.
i)
Never use damaged or invalid charger to charge to the battery.
j)
Always use the battery as scheduled.
k) Conduct proper battery recycle or disposal, and do not throw it into the scrap heap.
l)
Do not throw the battery into the fire.
WARNING: Any battery replaced from the instrument cannot be discarded at will,
which shall be recycled separately as per the chemical scrap list.
Section 4 analyzer startup and shutdown
Connect one end of the power cord provided together with the microwave analyzer in the packing box or
qualified 3-core power cord to the adapter provided together with the microwave analyzer. The
applicable voltage range is marked on the nameplate of the adapter, reminding users of using the
voltage as required. Connect the output end of the adapter to the supply hub on the cover plate (the
indicator light above the power switch on the front panel is on in yellow). Do not connect any equipment
to the microwave analyzer before startup. If everything is confirmed to be OK, start the microwave
analyzer, and the indicator light on the front panel will change to green at this time.
NOTE:
Do use the power adapter provided together with the microwave analyzer
or the built-in battery to supply power to the microwave analyzer, and
ensure proper power supply earthing. Otherwise, it cannot be used.
!
