HELPFUL HINTS
•
After plugging in the Wine Cellar and making your temperature selection,
allow the Wine Cellar to reach the set temperature before loading your
wine. This process may take up to 12 hours to completely stabilize.
•
After loading your wine, you may notice an increase in the temperature. Allow
enough time for the temperature to return back to your set temperature
setting. This may take up to 12 hours to completely stabilize.
•
The interior temperature during Normal Operation is displayed in
degrees Celsius.
•
The status of the refrigeration cycle is indicated by the
*
indicator light
as follows:
- Remains ON during the refrigeration cycle
- Remains OFF during the idle cycle
Interior Light
•
You can turn the light ON or OFF by pushing the light button located
on the right side of the control panel housing.
•
If the interior light is left on, the temperature will be higher.
CARE AND CLEANING
Replacing Light Bulb
1. Unplug the Wine Cellar.
2. The light bulb is located behind the light shield in the ceiling of the Wine
Cellar towards the front.
3. To remove the light shield, remove the screw with the appropriate screw
driver. Gently pull down on the bottom of the light shield to release it.
4. Unscrew the light bulb from the socket and properly dispose of it.
5. Replace with a 10 watt, 120 volt refrigerator bulb. This type of bulb is
available at most hardware and automotive parts stores.
WARNING:
Using a bulb rated higher than 10 watts may cause damage
to the Wine Cellar.
6
SAL7-579 Booklet Salton Wine Cooler WC-2038_EN VF_REV2.qxd 8/28/07 12:58 PM Page 6
