4
Do not allow aerosols, inflammable substances or materials sensitive to heat to be in the
flow of hot air.
Do not put the cable onto the appliance when it is still hot.
This appliance is not intended for use outdoors.
Do not use the heater on extremely deep-pile carpets!
OPERATING INSTRUCTIONS
Remove the appliance from the outer packaging and ensure that the appliance is intact.
Do not leave packaging materials such as bags and staples within reach of children or
animals/pets.
Set the heat on to a firm, level surface.
With the power switch in the “Off” position and the thermostat set at “Min”, plug in the
appliance. Ensure that the outlet has at-least a 10amp current carrying capacity.
Turn the power switch and select:
Fan only/1000W/2000W
Turn the thermostat control and set it from
SAFETY DEVICES
This appliance is fitted with two safety devices:
1.
The first safety device switches OFF the appliance when the radiator is tilted or
when it is tipped over. This is achieved by means of a switch situated in the
lower part of the radiator.
2.
The second safety device switches OFF the appliance should it overheat. This is
achieved by means of a built in thermo-fuse.
If either of the above situations should occur:
First ensure that it is not the thermostat that has switched off the heater. Turn the
power to maximum.
If the heater does not switch back on, the safety device has been activated.
Unplug the heater at the mains socket.
Allow the heater to cool down for 30 min.
Check if the heater has been placed correctly (refer section 3- Safety Positioning).
Ensure that nothing is obstructing the airflow.
If necessary, clean the grilles with a vacuum cleaner to remove any dust build up or
manufacturing dust.
Replace the plug into the wall socket and switch the heater ON again.
If the safety device again switches OFF the heater:
Unplug the heater from the mains wall socket
Have the heater inspected by an authorised service agent or by the supplier.
Summary of Contents for SFH460
Page 1: ...INSTRUCTIONS AND WARRANTY...
