5. Keep the Steam Button pressed and allow unit to continue cleaning for at
least 2 minutes.
NOTE:
More time may be necessary if the unit has not been cleaned
regularly. An additional minute or two is recommended if it has been more
than 3 – 4 uses since the last cleaning.
6. Once cleaning is complete, release the Steam Button and thoroughly shake
the Steam Nozzle over a sink or tub to remove excess water.
7. To set back to the normal steaming/iron function, press the Cleaning Switch
to the Iron position.
Troubleshooting
10
Problem
Cause
Solution
Excessive amounts
of water being
sprayed from the
Steam Nozzle
• Cleaning Switch is set
to ‘CLEAN’ mode
• Set Cleaning Switch to the
Iron position for normal
use
Unit produces loud
pumping sounds
when the Steam
button is pressed
• Air in Hose
• Low water level in
the Water Reservoir
• If unit has not been used
for a long period the Hose
will fill up with air. When
the Steam Button is
pressed the air must be
forced out as water is
pumped in
• Add water to the Water
Reservoir
Booklet_ST-1014_EN.qxd 4/1/08 5:54 PM Page 10
