Turntable Assembly
1. Turntable Shaft (floor of microwave)
2. Roller Ring
3. Glass Tray
4. Hub (underside of glass tray)
Center the Roller Ring over the Turntable Shaft on the floor of the Microwave.
Install the Glass Tray, centering the Hub over the Turntable Shaft. Turn the Glass
Tray slowly until the Hub engages on the Turntable Shaft.
• Never place the Glass Tray upside down. The Glass Tray should never
be restricted.
• Both the Glass Tray and Roller Ring must be used during cooking.
• Place all food and containers with food on the Glass Tray for cooking.
• Verify that the Glass Tray is properly engaged and rotating by observing
its rotation when you press the START/STOP button.
NOTE:
The Glass Tray
can turn in either direction.
NOTE:
If the Glass Tray or Roller Ring cracks or breaks, contact SWG Canada.
See the ‘Warranty’ section.
OPERATING INSTRUCTIONS
Signals during Setting:
One beep: oven accepts the entry
Two beeps: Oven does not accept the entry. Check and try again.
Setting the Clock
1. Press the CLOCK Button. (If you prefer not to use the clock display, touch Reset.)
2. Press the Number Buttons and enter the correct time.
Example: to set the time of 11:30, press the numbers 1,1,3 & 0, one at a time.
NOTE: You must press at least three numbers to set the clock (one for the hour
and two for minutes.
3. Press the CLOCK button to finish setting the clock.
NOTE:
•
If the numbers entered are not within a time range then the setting will not be
valid and the clock cannot be set.
•
In the process of setting the Clock, if the RESET button is pressed or if
there is no operation within 1 minute, the Microwave will go back to
the former setting automatically.
13
3
1
4
2
Booklet_MW-2047_EN.qxd 5/13/08 12:35 PM Page 13