5. Plug into a 120V AC wall outlet. The display will show the actual water
temperature. The Kettle is now in standby mode.
NOTE: If no selection has been made in 30 seconds, the display will
shut off and the Kettle will enter Sleep Mode. Press any button once
to “Wake up” the Kettle.
NOTE: Never plug kettle into an electrical outlet when the kettle is
empty.
6. Direct kettle spout away from cabinets, walls, etc. to prevent possible
steam damage.
7. The default temperature is 100°C (212°F). The variable temperature
range is 40 to 100°C (105 - 212°F) in 10 degree Celsius increments.
8. To boil water:
- Press the power button once.
- To switch between the Celsius and Fahrenheit display press the
°F/°C button for 3 seconds.
- The display will show 100°C (212°F) for 3 seconds then the display
will switch to the actual water temperature. The display temperature
will increase until the kettle reaches 100°C (212°F).
- Once the water has boiled the Kettle will shut off.
- The display will show 100°C (212°F) for 30 seconds then the display
will shut off.
9. To use the variable temperature settings:
- Press the °C/°F Button until you reach the desired temperature
between 40 –100°C (104 – 212°F) in 10 degree Celsius increments.
- To switch between the Celsius and Fahrenheit display, press the
°F/°C button and hold for 3 seconds.
- The display will show the chosen temperature for 3 seconds then
will switch to the actual water temperature. The display temperature
will increase until it reaches the chosen temperature.
- Once the temperature has reached the set temperature the Kettle
will shut off.
10.IMPORTANT:
a) The kettle shuts off automatically after the boiling cycle is complete.
b) If the kettle is removed from the base before the boiling cycle is
complete the boiling cycle will be cancelled.
c) To turn the kettle off before the boiling cycle is complete press the
Power Button.
11.The Lid should not be opened when the Kettle is hot.
12.Only grip the Kettle by the Handle as all other surfaces will be hot.
13.Return the Kettle to the Base or a heat resistant surface after use.
14.IMPORTANT: If the Kettle is accidently switched on when empty, the
thermostat will automatically cycle on and off to prevent the Kettle
from overheating. If this situation occurs unplug the Kettle
immediately and allow the Kettle to cool before refilling.
5
