2. Place Kettle on Base making sure it is correctly engaged on its Base.
3. Plug Power Base cord into a 120V AC wall outlet.
NOTE:
Never plug Power Base with empty Kettle into the electrical
outlet.
4. Depress the On/Off Switch to the ‘On’ position. The Indicator Light will
illuminate to indicate that the Kettle is in the boil cycle. Once the water
has boiled, the On/Off Switch will automatically switch to the ‘Off’
position and the Indicator Light will go out. NOTE: Direct kettle spout
away from cabinets, walls, etc. to prevent possible steam damage.
5. If you want to use the Kettle again, allow the thermal safety switch to
cool down for 15 – 20 seconds then depress the On/Off Switch to the
‘On’ position. If the On/Off Switch does not remain in the ‘On’ position,
the Water is hot enough to use without reheating.
6. Unplug cord from wall outlet before lifting Kettle from Power Base.
Grip the Kettle by the Handle only, as the surface and lid will be hot.
7. Return the Kettle to the Power Base or place on a heat resistant surface
after use.
8. If the Kettle is accidently switched on when empty, the thermostat will
automatically shut it off to prevent the Kettle from overheating. If this
situation occurs, unplug the Power Base and let the Kettle cool before
refilling.
9. It is recommended that the power cord be disconnected from the wall
outlet when not in use. DO NOT attempt to connect any other appliance
to the Power Base or tamper with the connector in any way.
CARE AND CLEANING
1. Unplug power cord from wall outlet. Empty out remaining water and
allow Kettle to cool before cleaning.
2. Use a soft damp cloth to clean the outside of the kettle.
DO NOT
USE ABRASIVE CLEANERS.
DO NOT
IMMERSE KETTLE OR POWER BASE IN WATER OR OTHER LIQUID.
DO NOT
ALLOW WATER TO ENTER THE POWER BASE.
4
6049_TGK760_Booklet_NA_ENG_Toastess Booklet 9/6/12 11:54 AM Page 4
