HOW TO USE
1. Fill the Water Reservoir with fresh cold water for the desired number of
cups.
NOTE: Do not fill above the ‘MAX’ line or less than the ‘MIN’ line indicated
on the Water Reservoir.
2. Press the Filter Basket Opening Button and the Filter Basket Holder will
swing outward. Fit a #4 coffee filter into the Filter Basket and fill with the
desired amount of ground coffee.
NOTE: Use coffee ground specifically for automatic drip coffee makers.
Usually one Coffee Measuring Scoop or a level tablespoon of ground coffee
is used for each cup of coffee. Adjust the amount to your personal taste.
3. Close the Filter Basket Holder.
NOTE: If the door does not close completely, check to see that the Filter
Basket and coffee filter are properly seated in the Filter Basket Holder then
snap the door into place.
4. Place the Carafe with Lid on the Keep Warm Plate.
5. Plug into a 120 Volt AC outlet.
6. Press the ON/OFF Button to the ‘On’ position and the Indicator Light will
illuminate indicating that the Coffee Maker is in the brew cycle.
NOTE: The brew cycle can be interrupted by pressing the ON/OFF Button to
the ‘Off’ position at any time. If you press the ON/OFF button again the
brew cycle will continue.
7. In a few minutes the coffee will be brewed and the Coffee Maker will auto
matically switch over to the ‘Keep Warm’ mode until the Coffee Maker is
unplugged.
‘PAUSE & SERVE’ FEATURE
The ‘Pause & Serve’ feature allows you to pour a cup of coffee before the brew
cycle has finished. Remove the Carafe slowly to temporarily stop the flow of
coffee. Quickly pour a cup of coffee and reposition the Carafe securely on the
Keep Warm Plate.
NOTE: Do not remove the Carafe for longer than 30 seconds.
4
Booklet_FC-1191_ENG:Salton Booklet 3/18/10 11:36 AM Page 4
