8
UK Clean Air Act 1993 - Smoke Control Areas
The Saltfire ST1 / ST1 Vision / ST3 wood-burning stove is suitable for use in smoke control areas when used in
accordance with these instructions.
WARNING- The high temperature paint covering the stove will give off some fumes during the initial few uses
of the stove. The fumes are non-toxic, but some people may find them unpleasant
–
Ensure the area is well
ventilated during this period.
The higher nominal output rating of this stove is based on around
1.5kg (for the ST1)
of seasoned logs which
would require refuelling every 60 minutes or
1.7kg (for the ST3)
of seasoned logs which would require
refuelling every 45 minutes.
This stove is suitable for intermittent burning and should not be used constantly for extended periods. Not
suitable for overnight burning.
Under certain abnormal weather conditions, e.g. down draughts, it may be difficult to get sufficient draw
through the appliance to achieve good combustion. When this happens, the stove should not be used.
IMPORTANT: -
As of October 2010, it is a legal requirement to use a Carbon Monoxide Detector in the same room as the
stove. This needs to incorporate a battery which lasts the life of the detector.
CLEANING/MAINTENANCE
Regular cleaning of the stove is essential for safety and efficiency. The ash-pan should be checked/ emptied at
least after every use, and during use if burning for longer periods. Extra care must be taken when removing
warm or hot ashes.
Step by step maintenance instructions:
1) A minimum of once per year the flue system should be cleaned/swept by a qualified chimney sweep or suitably
qualified stove installer. The servicing of the appliance can usually be carried out at the same time. Whether the system
needs sweeping more frequently than this will depend on use.
2) Baffle plate should be removed and checked for debris twice a year as a minimum depending on use.
Warped/misshapen baffle plates can be a warning sign that the stove has been over-fired (allowed to excessively heat
on one or more occasions).
3) Once removed, brush the baffle using a stiff brush or wire brush to remove any deposits. Clear any debris from the
upper parts of the stove above where the baffles normally sit.
4) Inspect firebricks on both the sides, rear and base for cracks - (some are normal and not a fault. Nor are they
detrimental to the workings of the stove, however it is good practice to be aware as any develop and over time if they
worsen, they may need replacing). If you feel a crack in the firebrick is just cosmetically unsightly it can be filled with a
small amount of fire cement.
5) Vacuum or brush out the inner stove box thoroughly.
6) Visually check that the glass is still making a good seal against its rope on the inside of the door frame and that it
’
s
retaining clips remain firmly in place to the touch.
