OWNER’S MANUAL V. 1 ENGLISH
PT-297 MOTORIZED TREADMILL
This manual is available at
www.salter.es
13
ENGLISH
BELT ALIGNMENT
If during use you notice that walking belt either shifts to the right or the left of center, first remove "Safety Key" and
unplug equipment from AC power source. Using M6 Allen wrench provided, turn left rear roller adjustment as
indicated below clockwise no more the 1/4" of a turn. Remove M6 Allen wrench, insert "Safety Key" and insert AC
power cord into AC outlet. Turn on your treadmill and observe after running a few minutes to see if problem has been
corrected. This may take several adjustments, so repeat the above procedure.
TREADMILL LUBRICATION
When total mileage accumulates to 100 km total running time to 150 hours, the system will show a lubrication prompt.
After this prompt is shown two times, the message will be deleted automatically.
It is important to lubricate periodically the treadmill.
WHEN YOU SHOULD LUBRICATE THE BELT?
1. After the first 25 hours of use (2-3 months).
2. Every 50 hours of use (5-8 months).
HOW TO CHECK TREADBELT FOR PROPER LUBRICATION?
Lift one side of the treadbelt and feel the top surface of the
treadboard.
If the surface is slick to the touch, then no further lubrication is
required.
If the surface is dry to the touch, apply one packet of lubricant or half
of the bottle of lubricant.
HOW TO APPLY LUBRICANT?
1. Lift one side of treadbelt.
2. Pour one half of the lubricant bottle under the center of the treadbelt on the top surface of the treadboard.
3. Walk on the treadmill at a slow speed for 3 to 5 minutes to evenly distribute lubricant.
NOTE:
DO NOT over lubricate treadboard. Any excess lubricant that comes out should be wiped off.
NOTE:
DO NOT over lubricate treadboard. Any excess lubricant that comes out should be wiped off.
