Salter Brecknell CS, User Instructions

Page: 5 / 13

5
Entering a Known Tare Weight With the Remote Control
You can key in a tare weight before placing an item on the scale by using the
remote control. Follow these steps:
1. With the scale on and showing 0.0 weight, press the RC MR key…
SHIFt is displayed.
2. Press the RC TARE key…
0000.0 is displayed with the left digit flashing. This is a prompt for you
to enter a known tare weight.
3. Press the RC TARE key to move the flashing digit to the right. Press the
RC M+ key to move the flashing digit to the left. When the digit you want
to change is flashing, press the RC 0 key…
The digit will increment each time you press the RC 0 key.
4. Repeat step 3 until you’ve finished entering the known tare value. Press
the RC MR key to accept this value and return to net weighing mode…
The TARE annunciator lights and the value you entered is displayed
as a negative number.
5. Hang the container, of the known tare weight you’ve entered, from the
hook…
0.0 is displayed.
6. Place the load to be weighed into the container…
The net weight is displayed.
7. To cancel the tare, press the TARE or RC TARE key. Repeat the
process as needed.
Using the HOLD Function
To hold a weight display after the load is removed, use the Hold function
described below.
1. With the scale on and showing 0.0 weight, hang the load from the hook…
The gross weight is displayed.
2. Press the RC HOLD key…
The scale beeps, the HOLD annunciator lights and the gross weight
is still displayed.
3. Remove the load from the hook…
The display remains unchanged. The weight will remain on the
display until you press the
RC HOLD key again.
4. Repeat steps 1 through 3 to perform another hold weighment.