2
INSTALLATION INSTRUCTIONS
1. MOUNTING THE SPREADER ONTO THE VEHICLE:
A.
Remove the tailgate from the vehicle (if equipped) as well as
any other object which will interfere with the spreader.
B.
Check truck’s bed for all kinds of sharp debris or foreign
objects. They can cut and seriously damage poly hopper.
C.
Remove chute, hardware kit from inside spreader. If spreader
has been used make sure there is no material left in the hopper.
D.
Prepare 4 boards as shown in Fig. 1. A board size is 2" x 4" x
60" long minimum. Boards can be as long as width of inside of
trucks body.
E.
Next, set the spreader in the truck body. Use four bars on the
frame to lift the spreader (Fig. 1).
Fig. 1
F.
Lower spreader onto 2" x 4" boards positioned in truck bed.
G.
Center the spreader on the vehicle with the end of the
gear mount 14" to the rear of the nearest vertical obstruction
(bumper, trailer hitch, etc). Attach chute to spreader, check
for interference between the vehicle and the Spinner/Chute
Assembly.
H.
Bolt the spreader to the vehicle frame through the lengths
of lumber using the holes located in each of the four (4) cross
members. Use 1/2" SAE Grade 5 hardware as required by
vehicle application.
I.
In addition, secure spreader using four ratchet straps or chain
tie down kit (sold separately). Always tighten straps evenly!
• The spreader must be securely fastened to the frame of the
vehicle.
• Verify with the vehicle’s manufacturer that the factory installed
anchor points are designed for tie-down of such load.
• Periodically check that the spreader mounting hardware is
securely tightened, retighten if necessary.
2. CONTROL BOX AND VEHICLE WIRING HARNESS
INSTALLATION
Make sure you have connected the proper wire color.
THIS IS WIRE GROUND ELECTRICAL SYSTEM! NO
CONNECTIONS TO TRUCK’S FRAME OR BODY ALLOWED!
NOTE: Always disconnect battery before attempting to
install electrical components on your vehicle.
A.
Mount the controller in a convenient location in the truck cab.
It is recommended not to mount the controller directly in front of
heat vents. Allow ample air space around controller.
B.
Route both wire harnesses into truck cab through firewall
(it may be necessary to drill holes). Insulate hole to avoid water
leaks.
C.
Insure no wires are nicked or damaged during installation.
D.
Connect the 4-pin connector on the wire harness to the
control box 4-pin connector.
CAUTION
Never lift spreader with material in the hopper.
WARNING
Do not drill holes into fuel tanks, fuel lines, through
electrical wiring, etc that may be damaged by
drilling. To insure good performance of your
spreader, check the condition of truck’s electrical
system. Using digital voltmeter, check alternator and
battery voltage. With engine running and head lights
and heater fan ON good voltage reading should fall
between 13.0 and 15.3 volts. If voltage reading falls
out of this range, check and adjust your electric
system.
CAUTION
Do not mount controller in the way of air bag
deployment!
WARNING
Do not drill holes into fuel tanks, fuel lines, thru
electrical wiring, etc that may be damaged by drilling.
CAUTION
Inspect straps and hardware after each time spreader
is loaded. Tighten straps and hardware if necessary.
WARNING
Important! Do not use ratchet straps or tailgate latch
exclusively! Always fasten spreader to the vehicle!
LIFT SPREADERS
USING THESE HOLES
