4
4. The SHPE0750 spreader is equipped with a dual
independent speed controller with warning indicators
and a vibrator switch. To start the spreader, press the
ON-OFF switch. Switch will illuminate. The auger will
accelerate to full speed for 2 seconds, then slow down to
dialed speed. The spinner will accelerate to full speed for
2 seconds, then slow down to dialed speed.
5. To activate the vibrator press the vibrator switch ON.
Vibrator switch will illuminate.
6. To stop the spreader, push ON-OFF switch to OFF position.
CONNECT
CONNECT
CONNECT
CONTROLLER #3014199
WIRE 36" LONG
#0203700
POWER CABLE
#3006842
MAIN WIRE
HARNESS #3006724
FUSE CONNECTOR
CONNECT TO FUSE
TERMINAL OR
IGNITION SWITCH
CONNECT TO
BATTERY
CONNECT TO CHUTE
CONNECT TO MOTOR
OPTIONAL
# 3018009
COMPARTMENT HARNESS
BROWN WIRE
CONNECT TO
UTILITY LIGHT
CONNECT TO
KNOWN GROUND
Fig. 6
Spreader Operation
1. Different materials absorb moisture at different rates and
some materials may not perform as desired. Substitution
of an alternative material may be necessary for optimum
performance.
2. When filling hopper use the supplied screen to prevent
large chunks of material and debris in the material to
get into hopper and cause damage.
3. Material must never be left in hopper for an extended
period of time. Material will absorb moisture, bind,
harden and could prevent spreader from proper operation
or may damage the spreader.
