Salsco 810, Operator And Parts Manual, Page: 23 / 31

O:\Manuals\810 CHIPPER\810 WOOD..BRUSH CHIPPER P.W. 10.30.2017.doc - 23 -
D. You have just told the machine each time you count the number in
the Calibration window that equals one R.P.M.
2. Setting the Hi & Low
A. Start the machine and raise to full R.P.M. (be sure to engage the
clutch so that the impeller is turning)
B.
Make a note of the number you see in the meter at full R.P.M. This
is “No Load R.P.M”
C. Shut the machine down.
D. Press and Hold both buttons until the meter gets dark and change
the Hi & Lo to the following numbers.
E. Change the Hi to be 100 less than the “No Load R.P.M.”
F. Change the Lo to be 100 less than the Hi.
G. All the other settings are set to zero.
H. Except machines with auto reverse on these machines set the back
to .250.
Setting Speed Sensing (Continued)