EN
3
BATTERY BACKUP
The clock, alarm and preset stations settings can be protected against AC power
failure with the batteries for a short period of time. If no backup batteries are
installed or the power failure is prolonged, you will need to set the clock again.
S
TANDBY MODE
Place the unit on a flat stable surface and plug the power cord into the mains
socket.
The unit is in standby mode and “0:00” will flash on the display.
SETTING THE CLOCK
1.
In standby mode, press and hold
SET
until the display flashes.
2.
Whilst the display is flashing, repeatedly press
HR
and
MIN
respectively
until the desired clock time appears.
Press and hold HR and MIN respectively for fast advance.
3. Press
SET
to confirm.
The hour and minute digits will stop flashing.
POWER ON/RADIO MODE
Press
POWER
to switch the unit on and enters the radio mode.
The radio frequency will briefly appear on the display and then return to
clock time.
RADIO OPERATION
1. Press
POWER
to turn on the radio.
The default FM frequency or the last frequency
you tune the radio to.
The default FM radio frequency is 87.5 MHz.
2. Press
BAND
once to enter the AM radio mode.
The default AM radio frequency is 522 kHz.
3. Repeatedly
press
BAND
to select the desired radio band.
4.
Adjust the volume by repeatedly pressing
VOLUME
/
.
5. Repeatedly
press
TUNING
/
to tune into the desired station.
Press and hold
TUNING
/
for about 2 seconds and then
release the button, the unit will scan the frequencies until a
broadcasting station strong enough for good reception is found.
