GB-3
3. Pair and connect to F-3088 on the BLUETOOTH audio source device. If prompted for
passcode, enter “0000”.
4. Pairing successful (LED indicator blue), ready to stream music.
5. Press PLAY/PAUSE button to pause or start the playback.
6. During playback, press TUNING UP/DOWN button to skip to the next or previous track.
Press and hold TUNING UP/DOWN button to search through the current track forward or
backward.
Note:
Pairing mode is canceled about 1.5 minutes.
The above are generic steps to pair a BLUETOOTH device, for more specific instructions
on BLUETOOTH connectivity for your device, please consult your manufacturer’s
manual.
RE-CONNECT TO THE BLUETOOTH AUDIO SOURCE DEVICE
If the device is already paired with the F-3088, but became unconnected even with both
Bluetooth devices turned on. You can re-connect them by following steps:
1. Press and hold the PAIR button to re-link the audio source device. The Bluetooth indicator
will blink for about 1.5 minutes for connecting.
2. Select F-3088 on the audio source device for connecting. Bluetooth indicator will turn to
solid blue if the F-3088 and the device have been re-connected successfully.
3. You can also re-connect the F-3088 by using Bluetooth operation of the device to be
connected.
FM RADIO
TUNING THE FM RADIO
1. Power on the unit, switch to TUNER(RADIO) mode by pressing SOURCE repeatedly.
2. Press TUNING UP/DOWN button to fine tune radio station. Press and hold TUNING
UP/DOWN button to auto search radio station forward or backward respectively (When
an available station can be found, the unit will broadcast it immediately and the searching
will be stopped).
3. In radio mode, it is possible to access the frequency via numeric buttons on the remote
control. For example, press buttons 8, 9 and 8 to get to 89.8 MHz; If you enter a wrong
frequency, "ERROR" will display on the screen.
4. During radio playback, press MO/ST button on the remote to switch between FM
STEREO and FM MONO modes.
STORING YOUR FAVORITE RADIO STATION
1. During playback, press MEM button on the remote for storing the current station until
memory cell number flashes on the screen.
2. Use CH+ or CH- button on the remote to select the corresponding memory cell among
P01-P20 for storing the station.
3. Confirm your selection by pressing MEM button on the remote.
4. During radio playback, press CH+ or CH- button on the remote repeatedly to recall the
stored stations.
