Daily
Manufacturer requires that the pedicure spa be thoroughly cleaned at the end of the day in following manner.
1. Remove the jet cover(fig 1). All debris trapped on or behind the cover must be removed. The jet cover must be free of
debris.
2. Before placing the jet cover, the cover must be immersed with EPA-registered disinfectant.
3. Flush out the whirlpool with low foaming detergent and warm water for 10 minutes.
4. With fresh water, EPA-registered cleanser for run the no pipe motor for 5 minutes.
5. Rinse with fresh water.
Weekly
1. Fill the basin with hot water up to its level.
2. Add 3 to 4 table spoons of a low foaming agent.
3. Run whirlpool for 5 minutes.
4. Stop whirlpool and sit for 5 to 7 minutes.
5. Open air control and whirlpool for 5 minutes.
6. Drain completely.
7. Fill the basin with warm water up to its level.
8. Apply EPA-registered disinfectant according to its direction.
9. Run whirlpool for 5 minutes.
10. Drain completely.
11. Wipe out excessive water with soft cloth.
12. Repeat step 7 to 10, if necessary.
double locking covers cleaning instruction(suggested by manufacturer)
1. Gently turn the cover counter clock-wise to remove. (Shown fig.1)
This will expose the entire water chamber.
2 Use antibacterial soap or a solution of 3% hydrogen peroxide to wipe the inner chamber.
Warning:
DO NOT use chlorine or chlorinated products (such as diluted bleach) as this will damage the
plastic, chrome cover and VOID your warranty.
!
N
E
P
O
C
L
O
S
E
Fig. 1
Maintenance
JJT Motor Cover
Luraco Motor Cover
P.11
