34
7. Blower Function
The vacuum cleaner can be used as a blower, e.g. for blowing dust, leaves, air filters, etc.
By connecting the suction hose to the blowing throat on the rear side of the vacuum head,
the air is blown out. By connecting the slit nozzle, you can better point the air flow.
See
Fig.
5.
Fig. 5
8. Storage and Maintenance
Before storage, perform the following:
1.
Remove the remaining liquid from the detergent tank, and flush it with clean water.
2.
Pour fresh water into the tank, connect it back to the vacuum cleaner, flush the hoses
and spraying jets. Drain the tank.
3.
Disconnect particular hoses by pressing the hose connector edge towards its centre and
pull out the hose.
4.
For easy cleaning of the vacuum hose, you can suck clean water from the sink or a
container into the vacuum cleaner. Do not immerse the nozzle into the liquid completely.
Leave a gap in the upper nozzle part to allow air supply.
5. After vacuum hose drying, you can use the blower function. First of all, drain excessive
water from the hose and then connect the blower inlet. This way you dry the hose more
quickly.
6.
Turn off the machine and disconnect if from the power supply. Then drain the main tank
and flush it with water.
7.
Remove the foam filter for drying. Re
-
install it for further wet vacuuming.
