Doc No. 500-650/v11.12
402 - 4/4
B
.
Fine Tuning
Use the bubble level to precisely adjust
the shelves. Be sure to level both sides
as well as front to back. Use the hex
key to tighten each peg.
6
Insert Side Panels
Carefully slide side panels
down center channel of
outside posts as shown. Be
sure the posts are square to
the bottom shelf to prevent
any damage to side panels.
Secure top with the 4 connector
bolts with hex key.
7
Secure Top
A
.
Insert Hardware
Combine the 1” threaded studs with the flat nuts. Slide 2 sets of hard-
ware down the two outside posts and 4 sets down the two center posts.
Allow studs to remain loose at bottom of post.
B
.
Position & Secure Studs
Align the Spacer Tool at the top of each post, then
position top studs through the small “Rear Panel”
hole. Repeat this step with the bottom studs
aligning the Tool along the bottom of post to set
spacing for cable passage.
Use the hex key to
secure the top and bottom studs to the posts.
C
.
Place Rear Panels
Secure each panel in place with thumb nuts.
1
2
3
4
5
6
7
8
9
S20 /
SVDO
REAR P
ANEL
41/2"
6"
8"
www.salamanderdesigns.com
EXTEN
DED
REAR P
ANEL
S30 /
S40
REAR P
ANEL
SP
ACER
TOOL
1
2
3
4
5
6
7
8
9
S20 /
SVDO
REAR P
ANEL
41/2"
6"
8"
www.salamanderdesigns.com
EXTEN
DED
REAR P
ANEL
S30 /
S40
REAR P
ANEL
SP
ACER
TOOL
2X
2X
REAR
Attach Rear Panels
4
A
.
Placing & Adjusting
Place shelves from the bottom up.
Angle the shelf in between the front
post and set on top of shelf pegs.
Use the Spacer Tool to adjust spacing
between shelves. Position the peg
through the Spacer and tighten.
5
Adjustable Shelves
A
B
SOFT CLOSE INSTALLATION
SLOW CLOSE
FAST CLOSE
